busted trailer plug receiver
#1
busted trailer plug receiver
Hey guys,
I noticed that my trailer plug receiver is busted...
Previous owner must have backed over something...
It was all bent under... the plastic is all cracked and busted, and that little spring loaded door is broken off...
It was Ford factory installed...
Any suggestions on repair/replacement.. without having to cut any wires? I would really like to keep everything OEM if possible.
Thanks
Dan
I noticed that my trailer plug receiver is busted...
Previous owner must have backed over something...
It was all bent under... the plastic is all cracked and busted, and that little spring loaded door is broken off...
It was Ford factory installed...
Any suggestions on repair/replacement.. without having to cut any wires? I would really like to keep everything OEM if possible.
Thanks
Dan
#3
#4
Hey Dan
You'll get more than dirt etc if the contacts ground out
Just get the replacement part...to rewire it is actually rather simple. Just pay attention to which wire goes where. Just look at old plug..rewire same way to new one..just dont do backwards like i once did. Really..its easy to do..if not paying attention.
Good luck...OT
You'll get more than dirt etc if the contacts ground out
Just get the replacement part...to rewire it is actually rather simple. Just pay attention to which wire goes where. Just look at old plug..rewire same way to new one..just dont do backwards like i once did. Really..its easy to do..if not paying attention.
Good luck...OT