I have come across a nice set of Screw front seats which I want to install in my 97 reg cab f150. I work in a salvage yard and have access to tons of parts,but I am not sure how to wire the power drivers seat up. I mean it couldn't be that hard....right? Anyone know which wires need to be hot and which ones are ground etc?? The Screw seats are out of a "99 (I think).
THANKS!!

 

After carefully looking at the Supercrew seats I realized the wiring harness only had two wires going to the power seat components, I ran a wire to the hot side of the power junction under the hood and cut cut the peice of harness I needed off of a 00 Expy. Everything worked out fine.

 

How did the installation go? I have always wanted to get new seats for my 97 reg cab but didn't think the extra cab or SCrews would bolt up. Did they or did you have to farbricate a new mounting system? I always liked the idea of the leather Harley Davidson seats, but never thought much more about it.

 

It actually went VERY smoothly. My truck had factory buckets with the console, and after removing them, the Screw seats basically just dropped right in. The only thing I noticed was the carpet has different cuts in it for the console, however unless you get out and look under the seat no one will ever notice but you. I am very pleased with the results and there were no modifications of any kind needed! If you have any questions just let me know