Problem with Level 2?????????
i have an 05 with 5.4, and a just got the edge for it to regear and to adjust for my new tire size, anywho i just customed tuned level 2 to : Level 2 Tow running 87octane
Timing +1
WOT Shift 1-2=5200 2-3=5200 3-4=4800
Shift Firmness 1-2=+4 2-3=+4 3-4=+2
Rev Limit 5400
WOT Fuel 1.5
Top Speed 110
Gear 3.73
Tire Size 2649mm (measured for 305/55/20s) (rounded off)
whenever im stopped and get going under 10mph, it "stutters" in to gear, im not sure if it is just relearning my driving habits, or should i change something???????
Timing +1
WOT Shift 1-2=5200 2-3=5200 3-4=4800
Shift Firmness 1-2=+4 2-3=+4 3-4=+2
Rev Limit 5400
WOT Fuel 1.5
Top Speed 110
Gear 3.73
Tire Size 2649mm (measured for 305/55/20s) (rounded off)
whenever im stopped and get going under 10mph, it "stutters" in to gear, im not sure if it is just relearning my driving habits, or should i change something???????
First off you're probably doing major (well not major but its not good) damage to your engine running timing up while running 87 octane. You might want to reread the manual there. Timing should be set at 0 while running 87.
Adjust your timing correctly then let us know if your still experiencing problems.
Adjust your timing correctly then let us know if your still experiencing problems.
Don't mess with idle rpms unless you want you want your truck to idle higher.
Shift firmness are personal preference.
Also with your shift points set at 200 below your Rev limit you might experience your truck bouncing off of the rev limiter before it shifts. I'm not sure what the best settings are but you can search around here and find the best settings to use.
Shift firmness are personal preference.
Also with your shift points set at 200 below your Rev limit you might experience your truck bouncing off of the rev limiter before it shifts. I'm not sure what the best settings are but you can search around here and find the best settings to use.
i left the idle rpms at 0 and i could feel the engine dying on me, it was reving down till i cut the power, and wat should i set my std. shift points at its in mph and not sure wat a safe start is??
Trending Topics
Originally Posted by bigmark
First off dont bump your timing up 1 with 87 octane.



