Disconnecting the Edge when not programming ?
Thread Starter
|
Junior Member
Joined: Jun 2006
Posts: 3
Likes: 0
From: Centreville Va.
Disconnecting the Edge when not programming ?
I'm new to the programming age, sooo,,, I just recieved my new Edge last night, and was wondering, I actually dont want to install it yet because I want to paint the housing and all to match my dash or even install it in my ash tray as I've read on here... sooo,, my question is,, can I set up the programmer, plug it in and set the programs on my ECU, then disconnect it until I'm ready to install and keep the benefit of the new programs ?
Senior Member
Joined: Nov 2005
Posts: 680
Likes: 0
From: Belleville, IL
Originally Posted by wlfbronco
I'm new to the programming age, sooo,,, I just recieved my new Edge last night, and was wondering, I actually dont want to install it yet because I want to paint the housing and all to match my dash or even install it in my ash tray as I've read on here... sooo,, my question is,, can I set up the programmer, plug it in and set the programs on my ECU, then disconnect it until I'm ready to install and keep the benefit of the new programs ?
yes, read the manual
