I am about to install an aftermarket amp into my 05 F150 Screw. I know where I am going to run the wires and how to run them, but I've got a couple questions before I get started.

1) How does the stock raido come out?

2) Can anyone direct me online to a wiring harness diagram to see where I should tap into remote/speakers?

3) What is the best gromet to go through the firewall on the drivers side?

Hope you guys can help me out or direct me to somewhere on the site that can. Thanks!

 

1) Pull the cupholder in the dash out just like you if you were going to stick a drink in it. Now, grab onto the trim piece that goes around the radio, houses the HVAC controls, cig lighter etc. You can stick your fingers under it right where it meets the cupholder and slowly yank it straight out.

Now there is a harness that plugs into the AirBag light that is above the radio. Unhook that and now you can set the trim piece/HVAC controls aside.

There are just 4 small bolts that hold the radio in then that you will be able to see. I believe they are 7mm...
Just slides right out then.

2)


3) Cant really help you on that one. Plenty of people have came in on the drivers side so they can be more of a help with that.