Truck with new wheels and 2010 Fx4 Decals Installed
Truck with new wheels and 2010 Fx4 Decals Installed
Thought I would share this with you guys. I picked up some Helo wheels from a guy and sand blasted then powdered them for a nice custom. Got them installed earlier today. Plus I put on all black Fx4 Decals compared to my old grey and red ones. Enjoy




Mods I have done to date are:
3" Leveling Kit with 1" rear block
Magnaflow Muffler
MBRP Black Tip
Husky Mud Flaps
Smoked tail lights
Smoked Cab Lights
Go Rhino side steps
Roll Up Cover
Swing Out Tool boxes
Bully Dog Bed step
Black Gas Cap
I think that is about it
3" Leveling Kit with 1" rear block
Magnaflow Muffler
MBRP Black Tip
Husky Mud Flaps
Smoked tail lights
Smoked Cab Lights
Go Rhino side steps
Roll Up Cover
Swing Out Tool boxes
Bully Dog Bed step
Black Gas Cap
I think that is about it
Nice ...
... but you need some pics in bright sunlight or sunsets, those pics have a grey back ground and wash out the truck. Some "contrast" maybe.
Is this the Bully Dog Step below? Is it pretty sturdy?
... but you need some pics in bright sunlight or sunsets, those pics have a grey back ground and wash out the truck. Some "contrast" maybe.Is this the Bully Dog Step below? Is it pretty sturdy?
Yeah the the side bed step. It flips in under the bed if you pull the handle and yes its very sturdy. Rated for like 350 lbs and it connects straight into existing holes in the frame. I never flip my in because I use it on a daily basis but you have the option if you like. I still need to get one for the other side but I keep forgetting to.
Looks sharp! I like your tails
I think painting your emblems to match your rocker panels or black would look sharp
I think painting your emblems to match your rocker panels or black would look sharp
Trending Topics
Yeah the the side bed step. It flips in under the bed if you pull the handle and yes its very sturdy. Rated for like 350 lbs and it connects straight into existing holes in the frame. I never flip my in because I use it on a daily basis but you have the option if you like. I still need to get one for the other side but I keep forgetting to.
Looks good but i have to point out that the decals are not where they should be.. The top of the decal should be about the same height as the top of the tail light. I had that same issue when i did custom decals on my previous trucks..
On a 2009 or newer truck you would be correct but on a 04-08 the decals where a bit higher. These are about an inch higher maybe then my old ones but to put them lower would of looked off. Go into my gallery and you will see the old decals above the light.
Last edited by Coskid; Jan 28, 2012 at 02:04 PM.
Thanks I wish they were just a bit darker of a smoked color but they are better then the old ones. Next will be mirrors and headlights.



