New Self Made Exhaust Installed
Senior Member
Joined: Jun 2006
Posts: 4,719
Likes: 0
From: Maricopa, AZ
Member
Joined: Apr 2008
Posts: 99
Likes: 0
From: MN
Killbee I see you are running the super swamper A/Ts! what do you think of them? I have seen they are going to come out with a 295/70/17 and thought this could be good insted of the Nittos that I am running now!
Thread Starter
|
Junior Member
Joined: Jun 2008
Posts: 8
Likes: 0
I like them alot, they ride really well for this big of a tire,hardly any noise at all. The only thing bad so far was geting them balanced, it took alot of weight on a couple of them to balance. Not an issue just more than normal, maybe its the size of the tire.
Technical Article Contributor
Joined: Jun 2005
Posts: 911
Likes: 0
From: Colorado
If he grinds like he welds, the outcome is the same.
Senior Member
Joined: Nov 2005
Posts: 17,118
Likes: 7
From: Burleson, Texas
Well at least if he grinds a hole in the exhaust he knows how to weld the hole he made closed.
Honestly it's easier to blow out a hole in the tubing with a welder than it is to grind a hole through it, especially if you don't know how to set up the welder properly. Grinding is just trigger and pressure.
Honestly it's easier to blow out a hole in the tubing with a welder than it is to grind a hole through it, especially if you don't know how to set up the welder properly. Grinding is just trigger and pressure.
Last edited by Stealth; Aug 2, 2008 at 02:16 AM. Reason: speeling
Technical Article Contributor
Joined: Jun 2005
Posts: 911
Likes: 0
From: Colorado
It's a vicious cycle, one that will end up in a 6" diameter bird poop bead.