I've searched the forums high and low and couldn't find the answer to my question. I'm getting ready to swap out my bench seat to the 40/60 seat. I'm trying to find out what size tap and die I will need. Will I need 2 different sizes for the seat bolt hole and seatbelt hole? If anyone could point me in the right direction either with a link or what ever it would be appreciated. Just trying to get everything lined out before I tear into this. As this is my daily driver. Thanks in advance.

 

here are the ones I used with the original hardware
12mm x 1.75 and a 10mm x 1.5 I converted 60/40 to bucket seats
and center console. I reused all O.E. hardware.

 

OK thanks.

 

yeppers