Here it is finished. I'm a little disappointed in the fact that its crooked (note the gap on the right hand side) but it was unavoidable. The dash curves out on the right, and I was unable to move any more to the left or it would interfere with the shifter. Non-4x4 or electronically controlled 4x4 shouldn't have that problem. This setup makes a nice tight fit. I put little rubber feet on the top of the CB to prevent scratches, then I had to push the CB into place (pushing against the black lower trim) to get it to fit. Really solid. Supported in the middle with the bracket, and top and bottom wedged by the dash.