Lights Behind Grille

June 9, 2011

8

3

KC 130w H3 Halogen SlimLites - Long Range Part No.121 Read more »

0 2011/06/09 15:52:35 carlschmar

2 2011/06/09 15:52:35 carlschmar

HK USP 40..."Certified Armorer!"

HK USP 40..."Certified Armorer!"

0 2011/06/09 15:52:35 carlschmar

Lights mounted on an old piece of scrap angle iron. I needed to use a grinder to narrow the ends down so that they would fit into the head light brackets...

Lights mounted on an old piece of scrap angle iron. I needed to use a grinder to narrow the ends down so that they would fit into the head light brackets...

0 2011/06/10 09:45:16 carlschmar

Three screws need to be removed from the lower part of the dash to be able to pop out the light part, then just disconnect the light switches.

Three screws need to be removed from the lower part of the dash to be able to pop out the light part, then just disconnect the light switches.

0 2011/06/10 09:45:16 carlschmar

I mounted the light switch next to the regular lights. It is NOT tied into the high beams, I wanted them on their own switch.

I mounted the light switch next to the regular lights. It is NOT tied into the high beams, I wanted them on their own switch.

0 2011/06/10 09:45:16 carlschmar

I need to aim/adjust them...

I need to aim/adjust them...

1 2011/06/10 09:45:16 carlschmar

This is where I went through the firewall. I then wrapped the KC Light wires with some scrap "wire protection" off an old wiring harness. This is just behind the brake fluid reservoir...

This is where I went through the firewall. I then wrapped the KC Light wires with some scrap "wire protection" off an old wiring harness. This is just behind the brake fluid reservoir...

0 2011/06/10 09:52:05 carlschmar