ABS sensor - anybody got a pic?

Old Sep 27, 2010 | 09:17 PM
  #1  
CWCobra's Avatar
Thread Starter
|
Senior Member
Joined: Dec 2004
Posts: 215
Likes: 0
From: Southeast TN
ABS sensor - anybody got a pic?

My ABS light comes on after I drive 10 miles. I suspect a bad sensor, or maybe just a dirty one. I'd like to track it down and clean it, but don't know what one looks like. Anybody got a pis? My ride is a 2008 Screw, 2WD,

Thanks,
CW
 
Reply
Old Sep 28, 2010 | 11:14 AM
  #2  
Blue07STX's Avatar
Senior Member
Joined: Aug 2010
Posts: 1,185
Likes: 0
From: Cabot, AR
Have you replaced your rotors?
 
Reply
Old Sep 28, 2010 | 01:04 PM
  #3  
CWCobra's Avatar
Thread Starter
|
Senior Member
Joined: Dec 2004
Posts: 215
Likes: 0
From: Southeast TN
Originally Posted by Blue07STX
Have you replaced your rotors?
No...still running original brake pads and rotors at approx 45,000 miles.

CW
 
Reply
Old Sep 28, 2010 | 03:32 PM
  #4  
iHellFire's Avatar
Senior Member
Joined: Dec 2008
Posts: 301
Likes: 0
From: Florida
dude ABS censors are nutorious for going out...cost like 50 bucks @ FORD and I believe its one the back side of the differential....right above the drive shaft...but there are more than one...
 
Reply
Old Sep 29, 2010 | 02:18 PM
  #5  
CWCobra's Avatar
Thread Starter
|
Senior Member
Joined: Dec 2004
Posts: 215
Likes: 0
From: Southeast TN
Guess I'll just go buy one at the parts counter, then look for something similar on the back side of the differentail to remove & replace.

I woulda thought, with such a high failure rate, somebody would have a pic.
I'll post a pic after I R&R mine.

CW
 
Reply
Old Sep 29, 2010 | 02:57 PM
  #6  
Blue07STX's Avatar
Senior Member
Joined: Aug 2010
Posts: 1,185
Likes: 0
From: Cabot, AR
Pull the tires in front, look behind and at the bottom of the rotor splash shield, there will be a small pencil eraser looking sensor facing the back of the rotor. Now, follow the sensor wire along the brake hose thru to the wheel well liner. Disconnect and replace. Don't forget to disconnect the battery and remove the sensor attach bolt on the back side of the splash shield before unclipping from the brake hose or disconnecting at the wheel well liner.

The cheapest I could find a FORD sensor was $130.00. If you can get one for $50.00 at the dealer I would replace them all. They may never be that price again...
 
Reply
Old Sep 29, 2010 | 04:36 PM
  #7  
iHellFire's Avatar
Senior Member
Joined: Dec 2008
Posts: 301
Likes: 0
From: Florida
Originally Posted by Blue07STX
Pull the tires in front, look behind and at the bottom of the rotor splash shield, there will be a small pencil eraser looking sensor facing the back of the rotor. Now, follow the sensor wire along the brake hose thru to the wheel well liner. Disconnect and replace. Don't forget to disconnect the battery and remove the sensor attach bolt on the back side of the splash shield before unclipping from the brake hose or disconnecting at the wheel well liner.

The cheapest I could find a FORD sensor was $130.00. If you can get one for $50.00 at the dealer I would replace them all. They may never be that price again...
true that man, i might of just caught them when they were overstocked or something...
 
Reply

Trending Topics

Old Sep 30, 2010 | 09:33 AM
  #8  
CWCobra's Avatar
Thread Starter
|
Senior Member
Joined: Dec 2004
Posts: 215
Likes: 0
From: Southeast TN
I'm guessing that there are a total of 3, right? One on each front wheel, and one on the diff? Assuming they are interchangeable (probably not), at $150 each, I'm gonna buy just one, and see if I can figure out which one is bad thru process of elimination. Sure hate to have to shell out $450 + tax.

Or...I could always just put a piece of black electrical tape over the ABS light on the dash, LOL!
 
Reply
Old Sep 30, 2010 | 01:14 PM
  #9  
iHellFire's Avatar
Senior Member
Joined: Dec 2008
Posts: 301
Likes: 0
From: Florida
Originally Posted by CWCobra
I'm guessing that there are a total of 3, right? One on each front wheel, and one on the diff? Assuming they are interchangeable (probably not), at $150 each, I'm gonna buy just one, and see if I can figure out which one is bad thru process of elimination. Sure hate to have to shell out $450 + tax.

Or...I could always just put a piece of black electrical tape over the ABS light on the dash, LOL!
Haha yes you could. See if they will just hook the computer up to the truck real quick and see if they will tell you which one and then go from there. Bu I'm sure they will charge you $90 for that.
 
Reply


Thread Tools
Search this Thread

All times are GMT -4. The time now is 03:17 AM.