i have a 2004 fx4 screw, looking at Moto Metal 951's 20x9 6.18bs and 30 offset and like to run a toyo open country MT 35x12.5x20. I have a 2.5 leveling kit ready to install. thanks

 

i think they might fit, but they may rub a little bit

 

It's gonna be close!! I'm gonna say.....most likely no.
Sorry

 

I agree it will be close...

I'm running a 2.5 inch spacer with 275/65/20's
About a 34" tall tire but on stock rims with no problems...

I here 35's on stock rims are ok. But aftermarket rims are pushing it.



AirAid modular intake tube, K&N filter, Magnaflow Exhaust, Line-X'd bed and fender wells, 2.5 Inch AS Level Kit and 3 inch AS Rear Block, 1 Mile range Viper 5900 SST remote start and alarm system, JL Audio Stealthbox, JL Audio 500/1, JL Audio 300/4, Alpine Type-R 6.5 inch components in front doors, Alpine Type-R 5x7's in rear doors, Alpine Iva-w505, LOTS of Dynamat, 15% Tinted windows, Billet Grills in factory H-bar and lower bumper.

 

No, I don't think 35's will fit with that wheel. I'd go with 33's(305/55-20)

 

^^Agreed. A 35x12.50 will only fit if you use the stock wheels.

 

they will fit

they will be very close to the control arm, and rub when at full lock.

i could barley fit my finger between the tire/ control arm

i had/have those Moto's in those specs and in the classifieds (hehe)

check out Grubrunner's rig