ABS light blinking and won't go into gear.
Thread Starter
|
Junior Member
Joined: Aug 2004
Posts: 4
Likes: 0
From: NC
ABS light blinking and won't go into gear.
Looking for anyone who has had this same problem....
After I replace the fuse which is no. 13 in the engine fuse box (a 15 amp fuse for Brake On/Off Switch, Rear Anti-Lock Brake Module, and Brake Pressure Switch), the truck will crank up and go into gear for about 12 to 24 hours. Then, after a night or so when I go to start the truck and drive off, the ABS light comes on and blinks. The gear will not come out of park either. After I check and replace the fuse again, this starts all over again.
Does anyone had this problem before or know whats going on here? Any help is much appreciated.
After I replace the fuse which is no. 13 in the engine fuse box (a 15 amp fuse for Brake On/Off Switch, Rear Anti-Lock Brake Module, and Brake Pressure Switch), the truck will crank up and go into gear for about 12 to 24 hours. Then, after a night or so when I go to start the truck and drive off, the ABS light comes on and blinks. The gear will not come out of park either. After I check and replace the fuse again, this starts all over again.
Does anyone had this problem before or know whats going on here? Any help is much appreciated.
