Help with seeping output seal on '01
Thread Starter
|
Member
Joined: May 2001
Posts: 65
Likes: 0
From: san diego, ca
Help with seeping output seal on '01
Hey out there!
I hold a Backyard Wrenchbender III certificate, and consequently,
seeps have never really bothered me. But on my '01?!?
The the output seal on the 4R70W has a seep that amounts to
just enough to have developed a stain on the crossover pipe
heat shield, and is visible as a little bubble on the lower half of the
seal. Fellow Wrenchbenders tell me that my daggon $25,000
'01 should be dry everywhere, and to get it fixed.
What do all you gentlemen and ladies say? It has 7K on it. Thanx!
I hold a Backyard Wrenchbender III certificate, and consequently,
seeps have never really bothered me. But on my '01?!?
The the output seal on the 4R70W has a seep that amounts to
just enough to have developed a stain on the crossover pipe
heat shield, and is visible as a little bubble on the lower half of the
seal. Fellow Wrenchbenders tell me that my daggon $25,000
'01 should be dry everywhere, and to get it fixed.
What do all you gentlemen and ladies say? It has 7K on it. Thanx!
