Cleaned the Thottle Body today.
Senior Member
Joined: Oct 2007
Posts: 3,439
Likes: 0
From: farmington hills, MI
yeah brew tell us your secerts my TB elbow and intake manifold are all pitted and look nasty. nothing like yours!!! once school is done i might get bored and do this. how long did it take you brew to take off the intake manifold clean it polish it and put back on?
Technical Article Contributor
Joined: Oct 2005
Posts: 25,641
Likes: 19
From: MI
Looks like I know what I am going to do tomorrow, I may even get brave and take off the whole intake manifold and give it a good cleaning and
also hopfully find out where some oil is coming from.
and hey jbrew what did you use to/how did you polish your TB and from the looks of it your manifold
also hopfully find out where some oil is coming from.
and hey jbrew what did you use to/how did you polish your TB and from the looks of it your manifold
Last edited by jbrew; Jun 12, 2009 at 02:54 AM.
Senior Member
Joined: Oct 2007
Posts: 3,439
Likes: 0
From: farmington hills, MI
Hey brew how much would you charge to do this to mine? ill drive out there and take it all apart if you do the cleaning and polishing.....you clean and polish my intake manifold and TB i wash and wax your truck? that sounds fair right?
Technical Article Contributor
Joined: Oct 2005
Posts: 25,641
Likes: 19
From: MI
Technical Article Contributor
Joined: Oct 2005
Posts: 25,641
Likes: 19
From: MI
I don't really have a list. I used allot of Dremel stuff. If you search porting the intake or polishing the intake, - look for ONELOWF posts and mine, I can't locate the site, but it's been published here in the past a few times. They sell kits and the worm/snake drives for that stuff. I don't have the info handy on this comp.
Last edited by jbrew; Jun 12, 2009 at 02:52 AM.
