Please Help

Thread Tools
 
Search this Thread
 
Old Dec 4, 2003 | 10:33 AM
  #1  
sleeperlover's Avatar
Thread Starter
|
Member
Joined: Nov 2003
Posts: 47
Likes: 0
From: Indiana
Please Help

Hey everyone, i have bought a keyless entry and car starter. I am installing it myself, and this thing is becoming a pain. I have a 91 F150 XLT Lariat, and they didnt make these wire harnesses very accesible.
What i was wandering about was, does n e one know where the relay for the door locks are. The diagram i got for my truck says that its in the kick panel. But, im not seeing n e relays in this panel. It also tells me to wire into the headlights, but i cant get to the wires behind the switch, and im having trouble tracing them down to another location. N e help on this matter is greatly appreciated. Thank u.
 
Reply
Old Dec 5, 2003 | 04:42 PM
  #2  
Throttle's Avatar
Senior Member
Joined: Nov 2001
Posts: 200
Likes: 0
From: Fort Worth
You would be better suited to posting this type of question on http://the12volt.com/

I have installed many toys in various vehicles and the people there have been a lot of help.
 
Reply
Old Dec 5, 2003 | 05:04 PM
  #3  
Hymis's Avatar
Member
Joined: Dec 2003
Posts: 35
Likes: 0
From: Oceanside California
Wiring problems are the worst! Always ends up to be somthing simple, its just a long road to get there. Worse case take it to a car stereo / alarm shop. You should be able to get our for less then $ 100.00 then you know its installed correctly. You wont have to worry about the system shorting out and leaving you locked out of your car. Especially if your installing ingition kill.
 
Reply
Old Dec 5, 2003 | 11:40 PM
  #4  
sleeperlover's Avatar
Thread Starter
|
Member
Joined: Nov 2003
Posts: 47
Likes: 0
From: Indiana
thanks guys, i have started it, and i am having trouble wth the start only, its like stupid. When u hit the button to start it, the fuel pump kicks on and runs then when it kicks off and starter SHOULD fire, it just stops and the starter computer clicks 3 times. I dont know if thats a code, becuz the manual is pretty vague. So, thanks again.


 
Reply




All times are GMT -4. The time now is 07:26 PM.