whatever happened to Talleywacker?

 

Talleywacker was suspending for violating vendor rules. It was too bad to see him go. But, he was pushing it for some time before, Steve suspended him.

You can find him in the other forums, if you need to.

 

Uh.. he got wacked..

 

Just want to point out that Talleywacker was 'Suspended' not 'Banned'.
Banned is permanent.
Suspended means there is still a chance he could graduate with the rest of his class.

 

Hope he comes back soon. Talley is one of the most knowledgable guys out there regarding the 4.2.

 

You can find Talley over at FordF-150.net

 

Talley is now our..oops,i mean he is now the 4.2 Guru at fordtruckworld.com

 

I didn't even know he was gone but then I haven't checked out the V6 section in a good while either so when did this happen.

 

He has been suspended for over two and a half months now, the weightlessness must be affecting him.

 

With as modded out as Talley has his truck he is well beyond the outer limits...

I am sure he is still around somewhere. He had, and if still on, has excellent information. A while back someone asked about recommendations for maintenance and I posted what Talley had posted for me. I still have them, I had printed them out and now are in my log book for future reference.



If he hasn't returned yet he may still be busy trying to get that Winston Cup motor to fit in his truck...

 

Talley's new best E.T. is 15.7 seconds in the 1/4. With a naturally aspirated 4.2. No Nos, and no blower.

 

Hey Moderator, I speak for many other board members. Please let Tallywacker back on the board. He is a valuable information source. Please reply one way or the other.

 

Maybe he found a cute blonde and has headed toward greener pastures..

 

a ported stock throttlebody, chip , pulley and a glass packs, electric fan and some ebay springs. do you really consider this the outter limits? high 15's in a shortbead single cab truck with a 5 -speed is descent but i think even talley would tell you this is not the outter limits.
how about some ported heads, a cam, roller rockers, fully ported intake, 10 to 1 pistons, 4.56 gears and a 150 shot of no2 would be a nice start for the "outterlimits"

 

"how about some ported heads, a cam, roller rockers, fully ported intake, 10 to 1 pistons, 4.56 gears and a 150 shot of no2 would be a nice start for the "outterlimits"

Naaaaaaa, screw that. I would just go with putting a Winston Cup motor in it. I think that would do it...