finally got the hydraulic clutch situation straightened out. Now the motor won't "catch", it turns over but it's not catching, definetly getting gas, pulled plug and it was covered in gas, seems like no spark. I was reading in the haynes manual it mentions about the camshaft position sensor (this was transferred from the old motor to the "crate" motor, unfortunately I may have not put it in the same position) The manual makes mention of a "Ford synchronizing tool" WTH is that?!?!?!?!?! I really need some help on this one fellas, any help would be appreciated. I will check to see if the coil is actually putting anything out tomorrow......until then......Brad