Help! (sorry double post from 2004 - Present)
Thread Starter
|
Senior Member
Joined: Dec 2006
Posts: 165
Likes: 0
From: Yellowknife
Help! (sorry double post from 2004 - Present)
I already posted this in the 2004 - Present section but I figure it will be better solved in here!
So this weekend a bunch of my friends and myself went out camping. My one buddy and I went to get firewood and had to drive down a ditch to get the dead fall. He is driving a '05 FX4 and he got stuck, his truck is completely stock. So we said F it and got a ride back to the camp site with a passer by to get my truck to pull him out. Now the only was I was able to pull him out was in reverse in 4x4 and when I was doing that I was pulling pretty hard and neither of us were moving and where the odometer is TRANS FAULT came on and the wrench light and the o/d light. So I tried to reverse and I no have little to no reverse and the tranny clunks but my drive gears work perfectly. I checked the error codes using Edge and I have a P1000 and a P0722.
P0722
------
OSS wiring
Insufficient input from OSS
PCM has detected a loss of OSS signal.
Harsh shifts, abnormal shift schedule, no torque converter clutch engagement.
WIRING OR OSS SENSOR
P1000
------
I read that it was just a self test thing that the trucks do.
Does anyone have any suggestions on what I could try or should I just bring it in to get fixed. Truck still has warranty.
So this weekend a bunch of my friends and myself went out camping. My one buddy and I went to get firewood and had to drive down a ditch to get the dead fall. He is driving a '05 FX4 and he got stuck, his truck is completely stock. So we said F it and got a ride back to the camp site with a passer by to get my truck to pull him out. Now the only was I was able to pull him out was in reverse in 4x4 and when I was doing that I was pulling pretty hard and neither of us were moving and where the odometer is TRANS FAULT came on and the wrench light and the o/d light. So I tried to reverse and I no have little to no reverse and the tranny clunks but my drive gears work perfectly. I checked the error codes using Edge and I have a P1000 and a P0722.
P0722
------
OSS wiring
Insufficient input from OSS
PCM has detected a loss of OSS signal.
Harsh shifts, abnormal shift schedule, no torque converter clutch engagement.
WIRING OR OSS SENSOR
P1000
------
I read that it was just a self test thing that the trucks do.
Does anyone have any suggestions on what I could try or should I just bring it in to get fixed. Truck still has warranty.