E4od trans failure
Thread Starter
|
Junior Member
Joined: May 2004
Posts: 2
Likes: 0
From: Henry IL
E4od trans failure
With in the last 2 months I had my e4od rebuilt and it ran good, until two days ago. The day prior it seemed to run fine and then I backed it out two days ago and then went and filled it up with gas. After leaving the gas station it would not shift up nor would it go into reverse, all I had is first gear and it worked fine. Any suggestions on what my problem could be would be greatly appreciated, the tranny fluid apears to be fine.
Senior Member
Joined: Dec 2002
Posts: 1,005
Likes: 0
From: Fairfax, VA
trans
IF yours has a vacuum modulator, the hose may have come off, but that normally would have no effect on reverse gear. If the rebuilder didn't properly tighten the filter/strainer bolts down, they might've come loose, and the trans is sucking air. What type of detent setup does it have, and is it connected?
SL
SL
Senior Member
Joined: Jul 2004
Posts: 1,380
Likes: 0
From: cincinnati
Re: trans
Originally posted by snappylips
IF yours has a vacuum modulator, the hose may have come off, but that normally would have no effect on reverse gear. If the rebuilder didn't properly tighten the filter/strainer bolts down, they might've come loose, and the trans is sucking air. What type of detent setup does it have, and is it connected?
SL
IF yours has a vacuum modulator, the hose may have come off, but that normally would have no effect on reverse gear. If the rebuilder didn't properly tighten the filter/strainer bolts down, they might've come loose, and the trans is sucking air. What type of detent setup does it have, and is it connected?
SL
