Here is what I need to know..


If I purchase this combo

6 inch BDS Lift
20x9 XD Spy with -12 Offset
35 inch Toyo or BFG KM2


Will this fit on the truck? AS in bolt on and go, or will i have to do some cutting and trimming due to rubbing at full turns thanks in advance.

 

It'll fit. might have MINOR rubbing but most likely non to very minimal

i had a very similar set up (6" bds, 9" wheel with -12 offset, and 35" BFG AT's) and only randomly had rubbing

 

Nice anyone got any Pics?

 

 

Nice i really like the look of the wider stance i didn't want to get the +18 offset with a 6 inch lift i felt it was a waste since you can put those on with just a leveling kit apparently

 

it will probably be just the front lower valence... just shave an angle on it and you are good to go.

 

nice thanks alot for the info. Should get done in a few weeks i will try and post before and after pics.