as it says....what is the thread pitch on the tie rod?

 

Not sure on thread pitch but one end is right handed thread, the other is left handed thread. You may already know this!

 

I think they are both right hand thread actually. I ordered this from www.mcmaster.com It is a M16x1.5 Die, part # is 2573A68 Cost was $14.56


heck buy my rear shocks and I'll send the die with them.

 

Can anyone verify the M16x1.5? Need to know tonight, planning on driving a few hundred miles tomorrow but have 1" of toe out...


Edit-just found another thread where bankrupt confirmed it...off to the hardware store since I done have metric dies...

 

nvmd...