Has anyone tried to fit 37's on a 6" pro comp stage 1 lift and just do some trimming to make it fit? Or does anyone know if it will work?

 

effonefiffty ran that set up for awhile

 

it depends on the specs of the wheel and a 37/12.5 would help aswell

 

I would add a little more lift by upgrading to the Pro Comp MX6 adjustable coilovers. Another less expensive option would be to replace your OEM coilover shocks with the OEM replacement Bilstien shocks. THese also feature adjustable spring preload to add up to 2 inches of lift.

 

I'm running a Procomp 6" + 2.5" spacer. I have 37x12.5 Kumho's and there's no way they would fit with just a 6" lift. I had to trim when I 35's with just 6". I also have -25 offset wheel. Maybe with a higher offset they would work.

 

WANDELL.... How much would those adustable coilovers cost?

 

If i'm wrong correct me, but I am pretty sure they are about $1,000, somewhere around that area

 

Yeah, the MX6 coilovers are pretty high. The oem replacement Bilstiens would be a lot less expensive.

 

do bilsteins, much cheaper than coil overs

 

And they would still be an upgrade from your OEM coilover shocks.

 

ill definently have to look into it because i really want 37's

 

Agreed! I have this same set up except I am running 36x15.5 and i had to do minor trimming! Definately not going to happen with just a 6" lift.

 

what gears and motor do you have?


check fabtech, they had blem coilovers a while back for $560 for both.

the bilsteins ride great tho, i drove fx4 for lifes a few months back on a trail and it was smooth as hell compared to my stockers

 

I have stock 3.73's with the 5.4 and an Edge tuner.

I may look into that, thank you.

 

My 37's are rubbing like crazy with an 8" lift. I'm just letting the tires "trim" away any extra plastic that is getting in the way. Fender flare, inner fender well, plastic running board. Going down the road and turning into a driveway or parking lot that has a bit of a hump is what causing me trouble