i have a 98 f150 with a 4.6l. i already have a procomp 4 inch lift. i am already craving more lift. i was thinking a three inch body lift and cranking the t-bars. if i do that what is the largest size tire i could fit without rubbing. i can trim the fenders too.

 

38x15.5 probably

 

i could fit 38s without rubbing?? i was thinking more along the lines of 37 13.50s. i do alot of flexing where i ramble so i would like it if it doesent rub.

 

ohh you have a 4inch....your right.....37x13.5 sound good to me

 

same here

 

will the 37s fit on the 4+3 with cranked tbars without rubbing at all or will i have to trim the fenders as well?

 

I believe you will have to trim a little bit depending on which wheels you have.

 

Your 4.6 is going to hate you with tires that big...

 

Yes it is...you will definitely need to regear

 

If you crank max the t-bars 37's should work. If you dont 36's would look pretty cherry too. MY 38's used to rub with the 6"+3", so i went to town on the trimming. But the bars arent cranked. They did clear when they were cranked to da max. but i kept tearing cv boots so i brought her back down.

 

is there 36s out there that will fit on a 17 inch rim? if so what are they.

 

i had my t bars cranked up like 1/2 inch but my cv joints are still pretty strait. what would i have to do for the rear to fit the 36 or 37s? my 33s tuck perfectly in the rear wheel wells. in my town there was a guy with a 4+3 setup with 40 boggers. it was insane.

 

40" boggers! He must have had fun with the sawzall. LOL! anyways i know they make the irok in a 36x13.50r17 and also a 37x 12.50. Where are you from?

 

***** i would really like to throw on some 37s but i really dont want to rub. i dont mind some trimming but what do you mean by massive trimming. im from big island kona side. i need bigger tires because the lava rock is gnarly around here. every time i go ulua fishing i have to ramble down insane a'a. so you think my engine would ***** with 37s haha.

 

I'd stick with a 37x12.50 to 37x13.50 tire.