Greetings earthlings.

I am contemplating a 6 inch suspension lift and have been looking at several install instructions to see how they are engineered.

The Fabtech instructions warn about severe balljoint wear and suggest inspection every 3,000 miles.

Does anyone here have a high(er) mileage Fabtech f150?

Thanks!

 

i have about 40,000 or so on my fabtech and it has caused no problems to speak of, and the balljoints where fine, good luck

 

Thanks for the reply.

It would be nice if someone made a nice straight axle conversion. I am always weary of lifting IFS vehicles.

 

i have been looking for a good solid axle swap for about a year, only thing i can find is the fabritech SAS and i was told the Quality is not that good if you come across one let me know

 

Same to you.

 

now i have a question.. i took my truck to get the aligment done.. 2 different places told me to that all 4 ball joints where done. where can i get the upper control arm ball joints? i have the fabtech upper arm and springs

 

I have 14000 on my Fabtech 6" and no joint wear. Still tight in the steering