I currently have a DJM 3/5 drop on 99xlt supercab with coils,hangers and shackles.
How much lower can I go without doing anything to the truck that is not 100% reversible? Just bolt on stuff. I also have the 2nd gen L wheels and tires, I would like to keep them on the truck as well.

Thanks in advance for any replies.

 

to go any lower u would have to c notch the frame and thats not reversable, sorry

 

Hey Blaq_ that is the same set up I want to run you have any pics of your truck

 

I have a 98 ext. cab. And I installed
a 4/6 drop on it myself. YOU DO NOT NEED
A C-NOTCH ON THE REAR UNLESS YOU GO LOWER THAN 6" IN THE REAR!!!!!!!! I have had
no problems with bottoming out.

FRONT = I replaced the lower A-arms & coils

REAR = flip kit on back w/no c-notch!!


SHOCKS = Belltech Nitro-drop shocks

 

4/6" drop... ***DROOL!***

got any pics, i want a low drop.

------------------
TRUCK
2000 XLT 4.2 Auto
3.55 non-limited slip
Superchip
K&N filter in airbox mod
custom ported STOCK throttle body

PC
Thunderbird 1.1ghz @ 1.33ghz
Abit KT7A-Raid
384mb Kingmax PC-150 ram
60gig IBM gxp RAID array
Geforce2 GTS 64mb

 

These were before I went another inch in the rear. I have 2" A-arms 2" springs with 1" coil cut....Western Chassis 2" hangers, 2" adjustable bracket and 3" de-arched leafs.
I may actually be closer to 5/7 than 4/6. I hit the frame terribly until I trimmed the lip of the frame a little (still hit but not as bad, need to notch it)

I have Ground Force shocks and it rides great(except for bottoming out every now and again...notch will fix that though) Handles good too, but will do better once I can get some 18" wheels on her.

------------------

http://www.my-f150.com/big.mike/

• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]
• [*]

[This message has been edited by big.mike (edited 03-20-2001).]