I am getting ready to have an amp and sub put in my 06 Fx4 Screw. How can I mount the under seat sub box without drilling holes through the floor board. i just can't get myself to do that. also what is a good noninvasive way to mount the amp.

how do these components look:
http://cgi.ebay.com/KICKER-KX400-1-M...QQcmdZViewItem

http://cgi.ebay.com/KICKER-2007-CVT-...QQcmdZViewItem

guess I'll get the box at supercrewsound or something like that.

Thanks!

 

If you are using a box made for under the seat, you should not have to bolt it down. The seats hold it in place. Even the box I built to hold my SI Mag is not bolted down. The seat jams down on top of it and keeps it in place.

 

This is the one I have. It'll rip your head off. No seat mod and stealthy.

They also make a double box, but honestly, IMO? That would be a waste of money, unless you wanna set off car alarms going down the street.







http://proboxrocks.com/ford/04upf150supercrew.shtml

 

RustyZipper,
What sub do you have in that box?

Dave

 

JL Audio 10W3v2.... 5.75 in. mounting depth.
With a JL 500/1 Slash Series
Class D Monoblock Amp, wired for single 4 ohm mono.
Dual ohm capable.

The box also comes with a grille.
I didn't use the grille as I keep the seat down.
Believe it or not, the sub sounds better
with the seat down.

Guaranteed to make your windshield wipers bounce.

http://mobile.jlaudio.com/products_amps.php?amp_id=252

http://mobile.jlaudio.com/products_s...p?series_id=11