While I had the intake off today I noticed the wires for the sensor was cut. I need a link to a wiring diagram all help is greatly appreciated!!!

 

http://www.autozone.com/autozone/myz...ipBenefits.jsp

 

There is no Crankshaft Position Sensor on a '93. The crankshaft position is sensed by the PIP sensor in the distributor. Is that what you're after?

 

Well I think it might be an explorer block and maybe that'd why it has that or and older block? I know it has GT 40 heads but it does have that sensor next to the crank pulley amd the wires are just cut and I didn't see any where to wire it up. So like you say I did see online that it does have PIP so I guess I shouldn't be worried about I then?

 

Ok just read that 95-96 blocks had that sensor called a misfire sensor for obd-II