Pre-1997 Models

95 flair side with codes Help!

Old Jan 13, 2010 | 08:34 AM
  #1  
axeman39's Avatar
Thread Starter
|
Junior Member
Joined: Jan 2010
Posts: 1
Likes: 0
95 flair side with codes Help!

Hi, I'm new here and I'm having a problem with my 95 flair side 302 automatic. While driving it will randomly bog down, check engine light comes on and it pops back thru the intake, I pull over shut the key off and re start and all symptoms are gone, power is back check engine light is out all is well. I pulled codes KOEO Pass, KOER Pass, KEEP ALIVE 172, 556, 668. Any help is appreciated Thanks.
 
Reply
Old Jan 13, 2010 | 06:50 PM
  #2  
S-crew03's Avatar
Senior Member
Joined: Aug 2004
Posts: 208
Likes: 0
From: Right here, Right now...
I'll be watching this too- (ironically) my 95 Flairside just started doing this as well. I'm sure it's not body specific though. When mine was bogging down and popping back through the air box, I just pumped the gas (then floor it) and it would clear. Only happens about once a week.
 
Reply
Old Jan 14, 2010 | 07:02 PM
  #3  
ymeski's Avatar
Senior Member
Joined: Aug 2008
Posts: 338
Likes: 0
From: Long Beach, Ca.
Originally Posted by axeman39
Hi, I'm new here and I'm having a problem with my 95 flair side 302 automatic. While driving it will randomly bog down, check engine light comes on and it pops back thru the intake, I pull over shut the key off and re start and all symptoms are gone, power is back check engine light is out all is well. I pulled codes KOEO Pass, KOER Pass, KEEP ALIVE 172, 556, 668. Any help is appreciated Thanks.
You have no active error codes at the time of testing, however your getting intermittant failures the qualified for continuous memory. #556 Fuel pump relay circuit failure (replace the relay), #172 o2 always lean(what is your o2 sensor setup & how old? 1 before the Cat,1 before the Cat, 1 after,2 before and 1after?)#668 Transmission circuit voltage above max range (not sure about that, my truck tranny it not ECU intigrated.)
 
Reply


Thread Tools
Search this Thread

All times are GMT -4. The time now is 03:11 PM.