Transfer case
Thread Starter
|
Senior Member
Joined: May 2004
Posts: 116
Likes: 0
From: Cape Cod
Transfer case
Anyone done any work to the trtansfer case? I am going to be doing something with my tranny and while it is apart was wondering if there is a bearing in the tailshaft where the driveshaft yoke slides in that I can replace?
Senior Member
Joined: Jan 2000
Posts: 3,205
Likes: 3
From: Along Lake Erie
Paging JMC.... Paging JMC....
I know there's a bushing on the output shaft that *can* be repaired, but it's quite costly IIRC. I've also heard that there's a company out there that can beef up the casting and bushing for less than a grand, although the name of the company escapes me at the moment....
JMC should have some more answers any minute now...
-Joe
I know there's a bushing on the output shaft that *can* be repaired, but it's quite costly IIRC. I've also heard that there's a company out there that can beef up the casting and bushing for less than a grand, although the name of the company escapes me at the moment....
JMC should have some more answers any minute now...
-Joe