4.9 power
Thread Starter
|
Junior Member
Joined: Feb 2004
Posts: 6
Likes: 0
4.9 power
I have a 1995 150 with a 4.9l straight 6. I tow alot with it and somtimes heaver loads. i would like to add more power but have not found any products for this engine. is there any? Do i have to think about switching engines?
Senior Member
Joined: Mar 2001
Posts: 345
Likes: 0
From: Waterloo, IA
Originally posted by Rascallyone
I put a set of headers on my 4.9L (from Clifford Research), an Offenhauser intake manifold and 390 cfm Holley 4 barrell (from JC Whitney) and a K&N filter.
I put a set of headers on my 4.9L (from Clifford Research), an Offenhauser intake manifold and 390 cfm Holley 4 barrell (from JC Whitney) and a K&N filter.
On my '92, I replaced the stock exhaust with 3" pipe and a large dump truck type muffler. I also installed a drop-in K&N intake filter. I did notice an increase in performance.
Member
Joined: Mar 2000
Posts: 26
Likes: 0
From: Chapin,SC
I didn't have fuel injection as mine was an 86model 4WD with 4 speed and granny low. It did seem to produce more tourque and beleive it or not but my mpg increased with the 4 barrell over the OEM single throat.