Any recommendations of a good Line-X shop in the northern Virginia area? I'm in Arlington, but don't mind a drive for quality work. Thanks.

 

I realize that the OP asked 8 months ago, but for the sake of the archive...

http://www.linexofsterling.com/

 

No offence jaitken, but I have had experience with them and the one that is located in Lorton, VA and the Lorton shop did a much better job on my 02 F150 than what the Sterling shop did on my 05 F150.

Lorton removed all hardware and I had no overspray anywhere. The Sterling shop did not remove the bed bolts. They also got overspray on my cab, my spare tire (a lot here) and the wiring behind the rear bumper - not that that matters much.

Both jobs were done through the purchasing dealer when I bought the trucks new.

It really depends on who does the work so that is not to say they do bad work, I just had bad experience with them when they did mine.

 

I was the original poster and I used the Sterling location. They were great. I had no overspray problems and they did a couple of extras that I requested (extending the spray over the bed end and tailgate end so that the surfaces that are exposed between the bed and the tailgate bottom - when the tailgate is down- are protected). Work was promptly done and really clean. All bed and tailgate bolts were removed and replaced. I highly recommend them on that experience, which was done on June 19, 2010.

 

I should get my truck this week and plan to use Line-X in Sterling. I'll let you know the result.

 

Just got my truck done. They did a good job and I'm happy with the result.

FYI for a short 5.5' bed they charged me $480, plus $175 for premium.
If you go with premium, remember there's a coupon on the Line-X website.

 

Just got my Line-X (sterling) through Sterling Ford (where I got my truck) and it was $409 after tax. Looks FANTASTIC, Sterling Line-X did a great job!