Guys,

I was hoping someone on this forum could answer a gauge install question for me.

I'm installing a single pod from autometer for a tranny temp gauge. How do I remove the A-pillar cover? I don't want to break anything during removal.

Any help is greatly appreciated.

John

 

If memory serves..just pop out the two square covers over the oh **** handle and remove the bolts. Then the Pillar trim should just pull off...

 

I have a 97, no handle on the drivers side. Anyother tips?

John

 

Do a search for my username and look at my thread about gauges. A lot of good info on there for you to read and to simplify your install.

 

Thanks ****,

I'll check it out.

John