SES light problem
Thread Starter
|
Member
Joined: Mar 2000
Posts: 87
Likes: 0
From: Duncanville, Tx US
SES light problem
What would cause this code:
(P0107) The PCM has determined the Manifold Absolute Pressure Sensor or the Barometric Pressure Sensor Input is Lower than expected for the current engine operating conditions.
My SES light used to come on because of my exhaust setup (no cats), but after I installed a 6lb lower pulley I called JDM and had that removed with my chip. About five or six startups later I get the SES light again. Thinking it is probably my exhaust again I let it go for about a week. Well I finally decide to get the code pulled by Autozone to see if it is my exhaust and I get this code above. So would this code be because of my exhaust or is it something else, like one of the sensors mentioned above?I really would like to get rid of this light, any help would be greatly appreciated.
(P0107) The PCM has determined the Manifold Absolute Pressure Sensor or the Barometric Pressure Sensor Input is Lower than expected for the current engine operating conditions.
My SES light used to come on because of my exhaust setup (no cats), but after I installed a 6lb lower pulley I called JDM and had that removed with my chip. About five or six startups later I get the SES light again. Thinking it is probably my exhaust again I let it go for about a week. Well I finally decide to get the code pulled by Autozone to see if it is my exhaust and I get this code above. So would this code be because of my exhaust or is it something else, like one of the sensors mentioned above?I really would like to get rid of this light, any help would be greatly appreciated.