I have bad wheel hopping when I lunch @ 1300 RPM's.
Does anyone have a pair of Metco Part# MTL9702 traction bars on the Lithtning. If so, how do you like it? Did nock off at least a 1/10th off your 1/4? These mount above the springs to not interfear with custom exhaust systems.

http://www.metco-inc.com/ford_lightn...acklinkmtl.htm

Thnx!

 

Clamp the two longer leaf springs together....in the front...A cheap way to deal with axle wind up and get better traction....Invest10-20 bucks and you`ll be amazed at the launch.
I have this and numerous others run this way.

 

i do !! cheap, i like cheap.

i woundering if i should put more the one on each leaf spring though ?

 

https://www.f150online.com/forums/sh...+spring+clamps

 

I tried clamping the 2 most forward leafs together last week. I am not too sure if I was able to tell any difference. Next time I will do runs with and without to tell. That is if I do not get traction bars and Nitto's by then

 

You could try a set of these. They bolt on in about 25 minutes with common hand tools and provide lift and traction.

 

I just installed some Lakewoods (21715) and they work great. Price shipped = $103

Can't wait to try them w/the ETstreets

 

The classic lakewood Vs. truck tracks debate...... should be fun. my vote Lakewoods.

-steve