For those who have the plate from PSP. What happens to the throttle linkage when you move the t/b further away from the intake? I was going to get my local machine shop to make one but it looks like there will be too much slack in the cable. Does it make a difference or am I just a idiot? Thanks, Mike

 

you use the supplied hardware. Sal has it figuired out

 

I guess my best bet is to just buy it from him them...........I guess there is another couple of weeks of waiting. Thanks

 

I ordered one the first part of this week. I talked with Sal today and he is supposed to have everything by the end of next week.!

 

I just talked to Mike before, but for Brian and everyone else, I revised the design on the plates and picked the new ones up this morning. I had the nozzle angle changed for a better shot into the intake, without being so close to the edge of the TB hole. There was nothing wrong with the old design, I just wanted to move the nozzle in a bit on the new ones. Both of you guys will get the new design.

 

Thanks for the update Sal!