hdmlnium? for u
Thread Starter
|
Senior Member
Joined: Dec 2000
Posts: 184
Likes: 0
From: BELLEVILLE N.J USA
hdmlnium? for u
i see u have the bell tech 3/4 lowering kit , my ? is this did u have to do like the instructions said and cut off all the rivets from the truck , if so do u have any ride problems with it . any info will be greatly appreciated later 
Senior Member
Joined: Jan 2001
Posts: 2,142
Likes: 0
From: Scarborough,Me. USA
SLPCAMAROSS98,
I did have to remove the front hangers to use the belltech ones. That was the hardest part of the install, I used my cut off tool and made some cross cuts into the rivets and then I used my air chizzel to punch the rivets out.
I think the ride is actually pretty good concidering the drop and the 30 series profile tires that I run. Everyone that has drove it or ridden in it said how surprized they were on how nice the ride was. Don't get me wrong it is stiff but very drivable.
Bill
I did have to remove the front hangers to use the belltech ones. That was the hardest part of the install, I used my cut off tool and made some cross cuts into the rivets and then I used my air chizzel to punch the rivets out.
I think the ride is actually pretty good concidering the drop and the 30 series profile tires that I run. Everyone that has drove it or ridden in it said how surprized they were on how nice the ride was. Don't get me wrong it is stiff but very drivable.
Bill