Shift Points
Thread Starter
|
Senior Member
Joined: May 2001
Posts: 129
Likes: 0
From: Louisville, Ky
Shift Points
I was just wondering what everyones shift points were after a chip install? I have a PSP chip and my L now shifts at around 5,500 RPM's. Also is there any problem going past redline for that split second.
Senior Member
Joined: Oct 1999
Posts: 2,497
Likes: 0
From: EVERYWHERE
I have had chips over the years that have shifted as high as 6K. But like shifts (for my truck) around 5600 rpm.
Dont think theres any problem hitting the redline for a split second.
For example:
When I do a burnot, I am actually running around 5500-6000 K during the last few moments as I roll out of the water box. I do this all the time, and have since the beginning with no problems.
Dont think theres any problem hitting the redline for a split second.
For example:
When I do a burnot, I am actually running around 5500-6000 K during the last few moments as I roll out of the water box. I do this all the time, and have since the beginning with no problems.
