JohnnyLightning was is the dimensions of your JL Performance pulley?
Thread Starter
|
Banned For Rules Violations
Joined: Mar 2001
Posts: 1,585
Likes: 0
From: Mobile, AL, USA
JohnnyLightning was is the dimensions of your JL Performance pulley?
Please, you never mentioned this in your other post (sorry if I didn't see it). I want the #'s so I can figure up what we'll be spinning and vs. PSP's and JDM's, etc.
I'm really worried about excessive heat more so than overspinning. Any comments on that?
BTW, when you measure, measure on the "OUTSIDE" of the grooves, not the insides, please.
Thanks pal!
BfB
I'm really worried about excessive heat more so than overspinning. Any comments on that?
BTW, when you measure, measure on the "OUTSIDE" of the grooves, not the insides, please.
Thanks pal!
BfB
Last edited by BfB; Aug 17, 2001 at 03:28 AM.
Senior Member
Joined: Jul 2001
Posts: 5,592
Likes: 0
From: Nashville
I am a little curious, and have some questions for you BFB. This is not a flame. I would like to know the answer. If there is extra heat, what could be wrong with that? If I go faster with more heat then what is the problem? Wouldn't JL power cooler negate the extra heat if any, and then some?
Senior Member
Joined: Feb 2000
Posts: 2,141
Likes: 0
From: lancaster,pa. usa
8.22 As far as excess heat. i was worried about that too. but like i said in a previous post as long as were still making more power and going faster,i don't believe we reached that point yet! thats my opinion of course. you'll have to make your own decision on that 1.....JL