I crawled under my 01 to install my cam bolt washers from Herb, and couldn't find the slot they went in. I need someone to show me in a picture I guess. I thought it was the front bolt on the lower A arm, but I couldn't find the slot. I called svt hotline and he said that my 01 shouldn't clunk because they fixed it.

P.S. Painted my brakes Blue this weekend will post picks tommarow. What is the easiest way to post pics?

------------------
'01 Lightning, JL Ram Air, JL Diablo Chip, Dynomax Muffler
'77 Harley Sporster, 74inch stroker motor w/all the trimings.
'96 Honda CBR 600, Jet kit, M4 pipe (Kills me to own Jap Crap, but it sure is fun)

 

flash,

I've read where the 01's do not have slotted lower control arms.

Here is a pic of where the washers go in/on a 99 and 00.

Keep in mind the cam bolts and washers are two different things. The cam bolts go on the upper A-arm to allow for proper alignment following installation of Herb's washers on the lower control arm.

hope this helps.



p.s. depending on one's 'puter knowledge, one of the easiest ways to post pics is to open a zing album (free) zing.com , upload the pics, and post away.

------------------
Brake Late, Dive Deep

Speedin Bob, Owner/Operator/Pilot
Lightning #2504, 6/17/99
NLOC # 438
**THIRD intercooler**



Zing Site Speedin Bob's pics

[This message has been edited by Speedin Bob (edited 06-13-2001).]

 

It's the one nearest the oil filter, lower rear drivers side one. Usually evidenced by slip marks like this photo.



------------------
Red '00 Lightning,
Power Surge Performance enhanced,
375 RWHP,
445 RWTQ,
12.974@104.818
Track Videos