water temp sender install
Thread Starter
|
Senior Member
Joined: Dec 1999
Posts: 382
Likes: 0
From: Brighton,Mi48114
water temp sender install
I see where speeding Bob put his sensor for the water temp guage. Is there a place where I can just screw the sensor in? Any pictures will be great. Thanks.
------------------
2000 F-150 4x4 Super Cab Oxford White Short box. Piaa Head light clear Front turn signals bulbs,5.4L,3.55ls, Superchip,Borla exhaust, K+N.. More to come.
2000 SVT WHITE LIGHTNING...
JDM PROGRAM chip
90 MM Mass Air Meter
Single Bore Throttle body
JDM Driveshaft,12" Cone Filter,2001 Headlights,tailights,turn signals, and center stop lamp.
Piaa head lamp bulbs
Precision Power amp PC4400
Pioneer 6x8 #TS-A6865 3-ways
Pioneer DEH-9200 Deck with Pioneer 6 disk. bassinni cat pipes and cat back.
Perma-tech sprayed in bedliner.
drop shackles
JL Ram Air Kit
JL Drive shaft loop
Lo-tek 3 guage pod for pillar.
code alarm with auto start.
------------------
2000 F-150 4x4 Super Cab Oxford White Short box. Piaa Head light clear Front turn signals bulbs,5.4L,3.55ls, Superchip,Borla exhaust, K+N.. More to come.
2000 SVT WHITE LIGHTNING...
JDM PROGRAM chip
90 MM Mass Air Meter
Single Bore Throttle body
JDM Driveshaft,12" Cone Filter,2001 Headlights,tailights,turn signals, and center stop lamp.
Piaa head lamp bulbs
Precision Power amp PC4400
Pioneer 6x8 #TS-A6865 3-ways
Pioneer DEH-9200 Deck with Pioneer 6 disk. bassinni cat pipes and cat back.
Perma-tech sprayed in bedliner.
drop shackles
JL Ram Air Kit
JL Drive shaft loop
Lo-tek 3 guage pod for pillar.
code alarm with auto start.
Senior Member
Joined: Sep 1999
Posts: 421
Likes: 0
From: minnesota
Cobra99,
There is no place to just screw the sender in. I am at the point in install one for my electric fan. Most people are drilling the thermostat housing out and tapping it. If you are installing the sender for a guage, putting the sender in the thermostat housing will cause the guage to not be accurate till the thermostat opens.
Brian
------------------
99 red lightning, bassani complete system #1610 of 4000
2001 Lightning, SVO throttle body
2000 super duty v10
Cobra "R" #131 of 300
Moderator
www.svtperformance.com
My vehicles http://www.zing.com/album/?id=4293160925
Cobra R At Road America
Cobra R Leaving Pit Road
There is no place to just screw the sender in. I am at the point in install one for my electric fan. Most people are drilling the thermostat housing out and tapping it. If you are installing the sender for a guage, putting the sender in the thermostat housing will cause the guage to not be accurate till the thermostat opens.
Brian
------------------
99 red lightning, bassani complete system #1610 of 4000
2001 Lightning, SVO throttle body
2000 super duty v10
Cobra "R" #131 of 300
Moderator
www.svtperformance.com
My vehicles http://www.zing.com/album/?id=4293160925
Cobra R At Road America
Cobra R Leaving Pit Road