Any of you guys every had this type of gap difference on your rear bumper? I was admiring my truck today and noticed the gaps was huge on the passenger side. I immediately got under to see if anything was hit, bent, or broken (the wife drove it to work last week). I didn't see any damage.
Any way to fix this or am I out of luck? Thanks. Take a look:

 

Crooked beds and sagging pipes are an undocumented feature of the Lightning. Get a torx and loosen the bolts in the top of the bed to align things a little better. Pay attention to the gap between the cab as well.

 

I have the smae problem going on with my 03 lightning also. Let me know if you figure it out

 

There is nothing to figure out. Just get under there, identify the bolts that secure the bumper- and loosen them a BIT, not all the way. Then shimmy the bummer into place (it helps having a second person to hold it, and make sure it is in the right place), and then tighten it back up. Voila.

I adjusted my front bumper on my Ranger as the factory location wasn't optimal (IMO, at least).

Should take 10 minutes...

 

Get a roll pan.

 

I think I'll keep it stock.