Vinnie is getting one BrianK has one and there's a few left over (as of 12-19-06)

https://www.f150online.com/forums/sh...=&pagenumber=1

 

Who in the hell is this SVTRobG cat???

 

Bahh, probably just some noobie....certainly noone thats ever been around the L scene.

 

looks good, works on screws right? what was the cost?

 

Flareside only.

 

screws have the same tailgate/rear end whats the difference?

 

What is that a Cervinis pan?

 

Flaresides have little steps at the front and rear of the bed. The end caps won't fit on your bed.


It's a ProGlass roll pan.

 

Where did you buy it? How much? and how was the install?

 

I remember seeing a post about this roll pan a long time ago. Same picture was shown then. Does anyone have a better pic of one that's finished? Also when you say that there's a few left over, do you mean there won't ever be any more of them made? Thanks.

,Marc

 

Rob,

Did you post a link about these in the first post??? What happens if I click on that...will it tell me all about the pans, who makes them, what they cost, how they fit and if they'll be available again?

 

 

from what im looking at its 3 peices. I really only need the middle section anyways since im doing a custom setup to delete the little corner flares behind my bumper, and have everything roll together just like the top 3/4ths of the bed is.
-Patrick

 

Man I'm a bumper guy, but damn that pan looks good. All it needs is fiberglass to make one molded piece.

 

Are they still 699?