Looking for an aluminum block to fit 3valve heads ??
Former Sponsor
Joined: Aug 2003
Posts: 987
Likes: 0
From: Freehold,NJ
Originally Posted by Don's Bolt
I am not 100% sure, but I think the 2 valve heads, the 4 valve heads, and the 3 valve Modular heads all use the same bolt pattern
Don is 110% correct
As far as it goes its either ours or the SHM/World block but they have an issue with the head dowels and coolant pockets matching up can be modified though. Ours is direct fit.
JimIII
Senior Member
Joined: Jan 2004
Posts: 902
Likes: 0
From: Tampa, FL
Originally Posted by JimIII@jdm
Don is 110% correct
As far as it goes its either ours or the SHM/World block but they have an issue with the head dowels and coolant pockets matching up can be modified though. Ours is direct fit.
JimIII
As far as it goes its either ours or the SHM/World block but they have an issue with the head dowels and coolant pockets matching up can be modified though. Ours is direct fit.
JimIII
If it were me .... I would go with JDM's block as to not have any issues
Former Sponsor
Joined: Aug 2003
Posts: 987
Likes: 0
From: Freehold,NJ
Originally Posted by rafa26
Does anyone know what kind of beam rods JDM uses on their aluminum block ?
h beam 4340 manley rods
afchad, yea world can make anything but $ and time are the two deciding factors. where as ours is set price and readily available.
JimIII
