Hi all,

I recently installed a ported HEaton and did the EGR delete mod to my L. I had the chip re-burned for both changes.

The following is copied from a message that I sent to my tuner, but I figured I would run it past everyone for 'grins';

I got my chip back and the L is up and running. The good news is that it feels STRONG! The bad news is I have a SES light.

I had the codes read at Auto Zone, there are three codes.

P0175 Sys too Rich (bank2)
P1132 Lack of HO2S11 Switch - Sens Indicates Rich

The last code I am not sure that I wrote down correctly, it is one of the following:

P1153 bank2 Fuel Ctrl Shifted Lean (FAOSC)
or
P1154 bank2 Fuel Ctrl Shifted Rich (FAOSC)

Any troubleshooting advice or course of corrective action that anyone could provide me would be greatly appreciated.

Thank you in advance!

Jake...

 

like everyone is probably thinking ,check for vacum leaks.make sure everything is conected properly and tightened fully. being that you did some exstensive work there is a good chance you missed something. go over everything you had to undo and so on.
thats the best i could tell ya unfortuneately posting issues about codes and things of the like will go nowhere in these forums everyone seems to be more concerned with lame a$$ crap or beaten to death issues. trust me i know i've been there and the few who do chime in are just that "the few"
it may not be much to go on but i hope it helps...good luck

 

Thanks for the reply. I have re-checked about everything I can think of that I was near. I will check again.

Thanks again!

Jake...