A few months ago I posted a thread about molding some gauges in my expedition console. After spending more time than I should have I realized I didn't like what I ended up with. Fast forward to last week I ordered the new console insert and started again this morning after staring at it for a few days. I like how this one turned out much better. I still have to buy another pack of gauge rings and also I need to finish sanding this one down to have it painted. After I epoxy the other ring in place I'm going to put a bead of filler around the rings to clean things up. I learned a lot by trashing the first so please bear with me. It might not be as good as Tampas but hey, it can only get better from here on out!

 

Nice,but will you be able to read them at WOT?

 

Yes I will. That's what the angled rings are for.

 

Nice work, now you need to buy a can of bondo and make the transitions smooth. There is alot of cool things you can do with those angle rings.

 

Nice work Dirt, I like it
and hey look at the brite side, it's cheaper than 2 motors and you didnt have to re-mortgage the farm to do it

 

Tampa, I already got the bondo covered. Let me know the pod is done.

 

What guages are you going to put in?
Boost,A/F ,Volts??

 

I already got a wideband so I'm thinking fuel pressure and oil pressure or something along those lines. I also have a surfboard pod coming from Tampablack so I might use the console for boost and nitrous pressure.