On-Dyno Nitrous Testing
Nice number's 
Senior Member
Joined: Aug 1999
Posts: 5,438
Likes: 1
From: Palm Coast, FL
Originally Posted by dirtchicken
He runs a Works. I tried to get one back in the day. That won't run 9s without some serious suspension mods.
Thread Starter
|
Senior Member
Joined: Sep 2001
Posts: 480
Likes: 0
From: Ventura, CA
Ok... Lets see, where to start 
Im not sure what the jet sizes are off hand for the 100shot, but its whatever is listed in the NX jet-chart for a 100shot. The facility is actually pretty nice. Very clean and they have mini "grand stands" setup for people to watch. The dyno does have teh 1/4 mile software built in, but the lights werent functioning yet or something...
Works 140 (Same Whipple 2300AX compressor that is/will be used in the whipple kits) with 8# Lower and 3" Upper... Makes between 20-23psi depending on the conditions...
Nothing fancy with the engine setup. Stock block (.020" over), stock forged crank, manley rods, JE pistons, etc.... hand-ported heads (Just cleaned up) with oversized valves and Stage 3 crowers.
If I had the satchel to spray the big shot on the track, it would probably run REAL close to a 9. But I dont, its too lean and Ive blown too many headgaskets already. It should run REAL hard on the 100shot though...
-Dale
Im not sure what the jet sizes are off hand for the 100shot, but its whatever is listed in the NX jet-chart for a 100shot. The facility is actually pretty nice. Very clean and they have mini "grand stands" setup for people to watch. The dyno does have teh 1/4 mile software built in, but the lights werent functioning yet or something...
Works 140 (Same Whipple 2300AX compressor that is/will be used in the whipple kits) with 8# Lower and 3" Upper... Makes between 20-23psi depending on the conditions...
Nothing fancy with the engine setup. Stock block (.020" over), stock forged crank, manley rods, JE pistons, etc.... hand-ported heads (Just cleaned up) with oversized valves and Stage 3 crowers.
If I had the satchel to spray the big shot on the track, it would probably run REAL close to a 9. But I dont, its too lean and Ive blown too many headgaskets already. It should run REAL hard on the 100shot though...
-Dale
Senior Member
Joined: Mar 2004
Posts: 437
Likes: 0
From: VA
Originally Posted by Dale-01L
Ok... Lets see, where to start
Works 140 (Same Whipple 2300AX compressor that is/will be used in the whipple kits) with 8# Lower and 3" Upper... Makes between 20-23psi depending on the conditions...
-Dale
Works 140 (Same Whipple 2300AX compressor that is/will be used in the whipple kits) with 8# Lower and 3" Upper... Makes between 20-23psi depending on the conditions...
-Dale
Last edited by 2bscrewed; Aug 30, 2005 at 05:13 PM.
