Balancer bolt tq spec?
Senior Member
Joined: Oct 2002
Posts: 2,840
Likes: 0
From: Bridgeport, MI
Tighten the crankshaft pulley bolt (6A340) in four stages. Stage 1: Tighten to 90 Nm (66 lb-ft).
Stage 2: Loosen 360 degrees.
l Stage 3: Tighten to 50 Nm (37 lb-ft).
l Stage 4: Tighten an additional 85-95 degrees.
Hope this helps amigo!
Peace,
Suavy
Stage 2: Loosen 360 degrees.
l Stage 3: Tighten to 50 Nm (37 lb-ft).
l Stage 4: Tighten an additional 85-95 degrees.
Hope this helps amigo!
Peace,
Suavy
Thread Starter
|
Senior Member
Joined: Sep 2003
Posts: 1,412
Likes: 0
From: Florida
Originally Posted by LightningTuner
Just FYI, ARP makes a replacement bolt that's not torque to yeild like the stocker.
Hum; but since it's on tq to yeild wonder what 37ftpds+90degrees would equal
I'm thinking 75~80 or so ftpds; maybe more?