Ok im puttin the NGK tr6s in but the only question i have is where are the plugs? i dont see any plug wires or anything is there a how too website?

 

Ah! You've not done them yet. Lay aside 4hrs for this the first time. (I'm not kidding)

Well... there is a coil pack on each plug. It's held in by a long bolt w/a 7mm hex head. These are placed just on the outside of each fuel rail. Unplug each coil pack, unbolt it, pull them pretty much straight up and then you'll see the plugs deep down in the hole that is now exposed.

Gap them to about 0.034" and torque the new plugs to 12-13ft lbs. You'll have a hard time getting a TQ wrench on the rear ones so just get a good feel on the front ones what 12-13ft lbs feels like.

One other tidbit.. loosening the drivers side brackets aids in pulling that side.

Rich