Hey All:

I'm thinking about putting a Kenne Bell on my otherwise stock truck.

I was thinking about pullying it for 15 psi.

Can anyone tune this with an SCT programmer instead of an actual chip?

Is the stock fuel system going to be adequate for that amount of power?

Does anyone have any ET guesses? My stock truck has run a best of 8.73 in the 1/8th.

Thanks!

Steve

 

you will need a dyno tune, but you can get the with one of the hand helds too..

I am running 15.5#'s right now on a stock block

 

With the KB pullied for 15#'s, PSP fast air, FTVB, Nitto's, and slappers I ran 12.02 In the 1/4 @ 115mph. I believe it was around a 7.57 1/8.

 

What is your timing set at ??

 

16*. It's never been above that.

 

Holy crap. That's nutty fast.

Who does your tuning?

Steve

 

Ed Clark. Local SCT tuner.

 

So, do you have to upgrade anything when putting a KB on a stock block?

 

Any idea what the density altitude (air quality) was when you ran that? I have a CAI and FTVB, Nittos and 12psi from the Eaton. I don't want to do a lot of extra mods. Just bolting on the KB, pulleying it conservatively and picking up 6mph in the 1/4 would be outstanding!

Good job!

 

I'm not sure. It was about 65* though. The very next week I added only a SBTB and ran 11.86 @116.1 on another 60* day.